# Licensed to the Apache Software Foundation (ASF) under one
|
# or more contributor license agreements. See the NOTICE file
|
# distributed with this work for additional information
|
# regarding copyright ownership. The ASF licenses this file
|
# to you under the Apache License, Version 2.0 (the
|
# "License"); you may not use this file except in compliance
|
# with the License. You may obtain a copy of the License at
|
#
|
# http://www.apache.org/licenses/LICENSE-2.0
|
#
|
# Unless required by applicable law or agreed to in writing,
|
# software distributed under the License is distributed on an
|
# "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY
|
# KIND, either express or implied. See the License for the
|
# specific language governing permissions and limitations
|
# under the License.
|
#
|
|
syscfg.defs:
|
BLE_PHY_SYSVIEW:
|
description: >
|
Enable SystemView tracing module for radio driver.
|
value: 0
|
|
BLE_PHY_DBG_TIME_TXRXEN_READY_PIN:
|
description: >
|
When set to proper GPIO pin number, this pin will be set
|
to high state when radio is enabled (TASKS_TXEN or TASKS_RXEN)
|
and back to low state on radio EVENTS_READY.
|
This can be used to measure radio ram-up time.
|
|
Note:
|
GPIO control for selected pin needs to be assigned to Network
|
Core, configure IPC_NRF5340_NET_GPIO in ipc_nrf5340 driver on
|
Application Core.
|
value: -1
|
|
BLE_PHY_DBG_TIME_ADDRESS_END_PIN:
|
description: >
|
When set to proper GPIO pin number, this pin will be set
|
to high state on radio EVENTS_ADDRESS and back to low state
|
on radio EVENTS_END.
|
This can be used to measure radio pipeline delays.
|
|
Note:
|
GPIO control for selected pin needs to be assigned to Network
|
Core, configure IPC_NRF5340_NET_GPIO in ipc_nrf5340 driver on
|
Application Core.
|
value: -1
|
|
BLE_PHY_DBG_TIME_WFR_PIN:
|
description: >
|
When set to proper GPIO pin number, this pin will be set
|
to high state on radio EVENTS_RXREADY and back to low
|
state when wfr timer expires.
|
This can be used to check if wfr is calculated properly.
|
|
Note:
|
GPIO control for selected pin needs to be assigned to Network
|
Core, configure IPC_NRF5340_NET_GPIO in ipc_nrf5340 driver on
|
Application Core.
|
value: -1
|
