ChinaUWBProject.git

			@@ -64,6 +64,7 @@
			#define SLEEP_START_TIME 120
			uint8_t enable_sleep_count,sleep_flag;
			#define DEBUG_MODE

			struct UART_CFG_T test_uart_cfg =
			{
			.parity = UART_PARITY_NONE,
			@@ -178,7 +179,7 @@
			group_id=g_com_map[GROUP_ID];
			memcpy(&dev_id ,&g_com_map[DEV_ID],2);
			tag_frequence=1000/g_com_map[COM_INTERVAL];
			g_com_map[VERSION] = (1<<8)\|6;
			g_com_map[VERSION] = (1<<8)\|5;
			LOG_INFO(TRACE_MODULE_APP,"设备ID: %x .\r\n",dev_id);
			LOG_INFO(TRACE_MODULE_APP,"固件版本:UWB-标签 V%d.%d. \r\n",g_com_map[VERSION]>>8,g_com_map[VERSION]&0xff);
			}
			@@ -220,7 +221,7 @@
			{
			board_clock_run();
			boot_deinit();
			board_pins_config();
			board_pins_config();
			board_debug_console_open(TRACE_PORT_UART0);
			// Reset reason
			reset_cause_get();
			@@ -250,7 +251,7 @@
			//sys_timer_open();

			gpio_open();
			//board_led_init();
			board_led_init();

			//uart_open(UART_ID0, &test_uart_cfg);

			@@ -264,11 +265,13 @@
			// Enable sleep timer
			sleep_timer_open(true, SLEEP_TIMER_MODE_RELOAD, sleep_timer_callback);
			//sleep_timer_start(__MS_TO_32K_CNT(g_com_map[COM_INTERVAL]));//测试
			sleep_timer_start(__MS_TO_32K_CNT(500));//测试
			sleep_timer_start(__MS_TO_32K_CNT(sleep_time_count));//测试
			//board_5V_input_init(voltage_input_handler);//有修改3.3V会一直高电平导致无法进入休眠
			// io_pin_mux_set(IO_PIN_5, IO_FUNC0);//波形测试
			// gpio_pin_set_dir( IO_PIN_5, GPIO_DIR_OUT, 0);
			// io_pull_set(IO_PIN_5 , IO_PULL_DOWN, IO_PULL_UP_LEVEL4);
			#ifdef BOXING
			io_pin_mux_set(IO_PIN_5, IO_FUNC0);//波形测试
			gpio_pin_set_dir( IO_PIN_5, GPIO_DIR_OUT, 0);
			io_pull_set(IO_PIN_5 , IO_PULL_DOWN, IO_PULL_UP_LEVEL4);
			#endif
			//Serial0_PutString("进入app测试\r\n");
			while (1)
			{
			@@ -277,8 +280,9 @@
			//LOG_INFO(TRACE_MODULE_APP, "测距ing");

			g_start_send_flag = 0;

			gpio_pin_set(LED_PIN);//亮
			TagRange();
			gpio_pin_clr(LED_PIN);//灭
			IdleTask();
			}else{
			IdleTask();