1.10，加入ota语音tts

WXK

2025-05-06 392e73cb409b1a8f295eafeac078f81b3904f9ec

 keil/include/main/main.c

@@ -28,6 +28,7 @@
//#define DEBUG_MODE
extern int simple_main(void);
extern int temp_main(void);
void boot_deinit(void);
#define TEST_UART_POLL_MODE 0
#define TEST_UART_INTERUPT_MODE 1
#define TEST_UART_DMA_MODE 2
@@ -131,22 +132,31 @@
{
    uart_receive(UART_ID1,m_EUART_DMA_RXBuf,EUART_RX_BUF_SIZE,uart_receive_callback);
}
uint8_t deep_sleep_falg=1;
void mcu_deep_sleep(void)
{
            uint32_t lock;
            trace_flush();
            lock = int_lock();
//                  LOG_INFO(TRACE_MODULE_APP, "进入深度休眠\r\n");
//            uint32_t lock;
//            trace_flush();
//            lock = int_lock();
////                  LOG_INFO(TRACE_MODULE_APP, "进入深度休眠\r\n");
//                  gps_air780_power_change(0,0);//关闭gps，4G 
             deep_sleep_falg=0;
            PCA9555_Set_One_Value_Output(LED_POWER,0);//输出低电平关闭LED
            PCA9555_Set_One_Value_Output(GPS_POWER,0);//关闭gps，4G 
                  PCA9555_Set_One_Value_Config(MAIN_RI,0);//配置4G唤醒引脚为输入
//                  PCA9555_Set_One_Value_Output(MAIN_RI,1);
             boot_deinit();
            CloseUWB();
            PCA9555_Set_One_Value_Output(AIR780E_ENBALE,0);//关闭gps，4G 
                     sleep_timer_stop();	
                  //adc_close();
            power_enter_power_down_mode(1);
//                  LOG_INFO(TRACE_MODULE_APP, "从休眠出来\r\n");
                  sys_reset(0);
            int_unlock(lock);
	          
//                  sleep_timer_stop();	
//                  //adc_close();
//            power_enter_power_down_mode(1);
//             delay_us(200000);

//             sys_reset(0);
////                  LOG_INFO(TRACE_MODULE_APP, "从休眠出来\r\n");
//            int_unlock(lock);			 
}
static void adc_callback(void *data, uint32_t number)
{
@@ -161,7 +171,7 @@
        {
            bat_percent = 0;
        }
        else if(fVoltage_mv > 4100)
        else if(fVoltage_mv > 4200)
        {
            bat_percent = 100;
        }
@@ -196,6 +206,7 @@
{
   if(nomove_count>g_com_map[NOMOVESLEEP_TIME]&&g_com_map[IMU_ENABLE]==1)
   {//power_wakeup_enable((enum POWER_WAKEUP_SOURCE_T)ACCLERATE_DETECT_Pin, POWER_WAKEUP_LEVEL_HIGH);
      power_wakeup_enable((enum POWER_WAKEUP_SOURCE_T)PCA_INPUT_DETECT, POWER_WAKEUP_LEVEL_LOW);
      mcu_deep_sleep();
   }
}
@@ -365,6 +376,7 @@
    send_struct.alarmDistence=prewarning_distance;//更新报警距离
    memcpy(&send_struct.gunLableId,&g_com_map[BIND_DEV_ID],2);//更新绑定ID
    send_struct.tagId=dev_id;//更新设备ID
     tag_frequency = 1000/g_com_map[COM_INTERVAL];

//    g_com_map[IP_0]=111;
//    g_com_map[IP_1]=198;
@@ -414,7 +426,7 @@
      }
    g_com_map[MODBUS_MODE] = 0;
      log_4g_enable_flag=g_com_map[LOG_4G_ENABLE];
    g_com_map[VERSION] = (1<<8)|7;
    g_com_map[VERSION] = (1<<8)|10;
         
        
    LOG_INFO(TRACE_MODULE_APP,"设备ID: %x .\r\n",dev_id);
@@ -467,7 +479,7 @@
            {
                nomove_count = 0;
//                adctick = HIDO_TimerGetTick();
                if(HIDO_TimerGetTick()-adctick>60)  //10分钟采样一次 电量
                if(HIDO_TimerGetTick()-adctick>600)  //10分钟采样一次 电量
                {
                    chongman_time=chongman_time+60;
                    adctick = HIDO_TimerGetTick();
@@ -479,7 +491,7 @@
                only_one_flag=1;
                chongman_time=0;
                }
                if(bat_percent>=99&&chongman_time>=600)
                if(bat_percent>=99&&chongman_time>=180)
                {
                    powerled = GREEN;
                }else{
@@ -523,6 +535,7 @@
                        g_com_map[CNT_RESTART]=0;
                        save_com_map_to_flash();
                        NVIC_SystemReset();

                    }
                }
                else
@@ -557,7 +570,7 @@
        {
            g_com_map[CNT_RESTART]=0;
            NVIC_SystemReset();
            
         
        }
        if(g_com_map[MAP_SIGN_INDEX]!=0x55AA||g_com_map[COM_INTERVAL]==0)
        {
@@ -580,9 +593,12 @@
// UART0 TX/RX
    io_pin_mux_set(IO_PIN_5, IO_FUNC0);
    io_pin_mux_set(IO_PIN_6, IO_FUNC0);
     gpio_pin_set_dir(IO_PIN_5 , GPIO_DIR_OUT, 0);
     gpio_pin_set_dir(IO_PIN_6 , GPIO_DIR_OUT, 0);
    // UART1 RX/TX
    io_pin_mux_set(IO_PIN_10, IO_FUNC0);
    io_pin_mux_set(IO_PIN_9, IO_FUNC0);
	
    uart_close(UART_ID1);//解绑原来串口1
    uart_close(UART_ID0);//解绑原来串口0
}
@@ -599,13 +615,14 @@
                switch(elapsed_time_jibu)
                  {
                     case UWB_OPEN_COUNT:

                              CloseUWB();	
                            CloseUWB();
                            uwbled = LEDOFF;
                     break;
                     
                     case UWB_MEASUREMENT_INTERVAL:
                              OpenUWB();	
                    state_start_time = uwb_time_count;							
                            OpenUWB();
                            uwbled = BLUE;							
                   state_start_time = uwb_time_count;							
                     break;                  
                  }
            break;
@@ -684,6 +701,7 @@
    IIC2_Init();
    Accelerometer_Init();
    PCA9555_init();
    WT588E02B_Init();
    adc_open(&usr_adc_cfg);
    uart_receive(UART_ID1,m_EUART_DMA_RXBuf,EUART_RX_BUF_SIZE,uart_receive_callback);
    power_init();
@@ -714,6 +732,7 @@
    while (1)
    { 
        uwb_app_poll();
//           upload_apppoll();
        Internet_Poll();
        HIDO_TimerPoll();
        HIDO_ATLitePoll();