ChinaUWBProject.git

			@@ -44,7 +44,7 @@

			#define UWB_OPEN_COUNT 1
			#define UWB_MEASUREMENT_INTERVAL 5
			#define UWB_MEASUREMENT_INTERVAL_SLEEP 60
			#define UWB_MEASUREMENT_INTERVAL_SLEEP 30

			extern uint8_t mUsartReceivePack[100];
			extern uint8_t mUsart2ReceivePack[150];
			@@ -79,11 +79,7 @@
			} Operation_step;

			Operation_step UWB_work_state;
			// 定义状态
			typedef enum {
			STATE_NORMAL, // 正常状态，3秒测距上传一次
			STATE_SLEEP // 休眠状态，1分钟测距上传一次
			} CountState_t;


			uint32_t uwb_time_count = 0; // 定时器计数值
			//uint32_t step_count = 0; // 步数计数
			@@ -114,7 +110,7 @@
			.flow = UART_FLOW_CONTROL_NONE,
			.rx_level = UART_RXFIFO_CHAR_1,
			.tx_level = UART_TXFIFO_EMPTY,
			.baud = BAUD_9600,
			.baud = BAUD_115200,
			#if (TEST_UART_MODE == TEST_UART_POLL_MODE)
			.dma_en = false,
			.int_rx = false,
			@@ -144,8 +140,9 @@
			deep_sleep_falg=0;
			PCA9555_Set_One_Value_Output(LED_POWER,0);//输出低电平关闭LED
			PCA9555_Set_One_Value_Output(GPS_POWER,0);//关闭gps，4G
			PCA9555_Set_One_Value_Config(MAIN_RI,0);//配置4G唤醒引脚为输入
			// PCA9555_Set_One_Value_Output(MAIN_RI,1);
			// PCA9555_Set_One_Value_Config(MAIN_RI,0);//配置4G唤醒引脚为输入
			//
			//// PCA9555_Set_One_Value_Output(MAIN_RI,1);
			boot_deinit();
			CloseUWB();
			PCA9555_Set_One_Value_Output(AIR780E_ENBALE,0);//关闭gps，4G
			@@ -210,6 +207,14 @@
			power_wakeup_enable((enum POWER_WAKEUP_SOURCE_T)PCA_INPUT_DETECT, POWER_WAKEUP_LEVEL_LOW);
			mcu_deep_sleep();
			}
			}
			void powerON_Task(void)
			{
			if(deep_sleep_falg==0)
			{
			PCA9555_Set_One_Value_Output(PWR_ENABLE,1);
			}

			}
			void UserKeyTask(void)
			{
			@@ -307,19 +312,26 @@
			}
			uint8_t tt=1;
			uint8_t flag_sleeptimer,flag_secondtask,secondtask_count,log_4g_enable_flag;
			uint8_t uwb_enable_flag=0;
			uint8_t uwb_offtime_count=0;
			uint8_t input5v_time;
			extern uint8_t taglist_num;
			uint8_t gps_ntripsend;
			static void sleep_timer_callback(void *dev, uint32_t time)
			{
			// powerON_Task();
			if(secondtask_count++%2==0)
			{
			input5v_time=1;
			flag_secondtask = 1;
			#ifdef UWB_1_5HZ
			uwb_time_count++;
			#endif
			#endif
			uwb_offtime_count++;
			if(uwb_offtime_count>60)
			{
			uwb_offtime_count=0;
			// current_state = STATE_SLEEP;
			}
			if(!read_5v_input_pca())
			{
			if(bat_percent>15)
			@@ -431,7 +443,7 @@
			}
			g_com_map[MODBUS_MODE] = 0;
			log_4g_enable_flag=g_com_map[LOG_4G_ENABLE];
			g_com_map[VERSION] = (1<<8)\|8;
			g_com_map[VERSION] = (1<<8)\|14;


			LOG_INFO(TRACE_MODULE_APP,"设备ID: %x .\r\n",dev_id);
			@@ -613,48 +625,51 @@
			void upload_apppoll()
			{
			uint32_t elapsed_time_jibu;
			#ifdef UWB_1_5HZ


			switch (current_state)
			{
			#ifdef UWB_1_5HZ
			case STATE_NORMAL:
			elapsed_time_jibu = uwb_time_count - state_start_time;
			switch(elapsed_time_jibu)
			{
			case UWB_OPEN_COUNT:
			CloseUWB();
			// uwbled = LEDOFF;
			UWBSendUDPTask();
			GPS_UPLOAD_FLAG=1;

			break;

			case UWB_MEASUREMENT_INTERVAL:
			OpenUWB();
			// uwbled = WHITE;
			taglist_num = 0;
			CloseUWB();
			Uwb_init();
			OpenUWB();
			state_start_time = uwb_time_count;

			break;
			}
			break;
			#endif
			case STATE_SLEEP:
			elapsed_time_jibu = uwb_time_count - state_start_time;
			switch(elapsed_time_jibu)
			{
			case UWB_OPEN_COUNT:

			CloseUWB();
			CloseUWB();
			UWBSendUDPTask();
			break;

			case UWB_MEASUREMENT_INTERVAL_SLEEP:

			OpenUWB();
			state_start_time = uwb_time_count;
			taglist_num = 0;
			CloseUWB();
			Uwb_init();
			OpenUWB();
			state_start_time = uwb_time_count;
			break;
			}
			break;
			}
			#endif

			}

			uint8_t flag_4guart_needinit=0;
			@@ -665,12 +680,17 @@
			uint32_t test4;
			extern uint8_t receive_flag;
			int main(void)
			{
			{
			__enable_irq();
			board_clock_run();
			boot_deinit();
			board_pins_config();
			gpio_open();
			IIC2_Init();
			Accelerometer_Init();
			PCA9555_init();
			board_debug_console_open_baud(TRACE_PORT_UART1,BAUD_115200);

			// Reset reason
			reset_cause_get();
			reset_cause_clear();
			@@ -684,7 +704,7 @@
			}
			else
			{
			board_calibration_params_default();
			board_calibration_params_default();
			}
			calib_chip();
			wdt_close(WDT_ID0);
			@@ -706,11 +726,11 @@
			TCPClient_Init_1();
			}
			// HTTPClient_Init();
			gpio_open();

			LED_output_init();//配置彩色灯引脚
			IIC2_Init();
			Accelerometer_Init();
			PCA9555_init();


			WT588E02B_Init();
			adc_open(&usr_adc_cfg);
			uart_receive(UART_ID1,m_EUART_DMA_RXBuf,EUART_RX_BUF_SIZE,uart_receive_callback);
			power_init();
			@@ -740,8 +760,12 @@
			gps_prase_flag=1;//恢复gps解析
			uart1_change_from_debug_to_gps();//测试
			PCA9555_Set_One_Value_Output(MCU_A,0);//输出低电平切换为GPS
			#ifdef UWB_CG
			CloseUWB();
			#endif
			while (1)
			{

			uwb_app_poll();
			Internet_Poll();
			HIDO_TimerPoll();