| | |
|---|
| | | struct BOARD_PARAM_T board_param = {0}; |
|---|
| | | static GPIO_IRQ_HANDLER_T button_irq_handler = NULL; |
|---|
| | | static GPIO_IRQ_HANDLER_T accelerate_irq_handler=NULL; |
|---|
| | | |
|---|
| | | static GPIO_IRQ_HANDLER_T _4Gusart_irq_handler=NULL; |
|---|
| | | extern struct UART_CFG_T test_uart_cfg; |
|---|
| | | void board_clock_run(void) |
|---|
| | | { |
|---|
| | | // default load cap |
|---|
| | |
|---|
| | | accelerate_irq_handler=irq_handler; |
|---|
| | | gpio_pin_set_dir(ACCLERATE_DETECT_Pin , GPIO_DIR_IN, 0); |
|---|
| | | io_pull_set(ACCLERATE_DETECT_Pin, IO_PULL_DOWN, IO_PULL_UP_LEVEL4); |
|---|
| | | gpio_enable_irq(ACCLERATE_DETECT_Pin, GPIO_IRQ_TYPE_RISING_EDGE, accelerate_irq_handler); |
|---|
| | | gpio_enable_irq(ACCLERATE_DETECT_Pin, GPIO_IRQ_TYPE_RISING_EDGE, accelerate_irq_handler); |
|---|
| | | } |
|---|
| | | void board_4GUsart_detection_init(GPIO_IRQ_HANDLER_T irq_handler) //4G 串口输入检测中断，下拉触发 |
|---|
| | | { |
|---|
| | | _4Gusart_irq_handler=irq_handler; |
|---|
| | | |
|---|
| | | io_pin_mux_set(_4G_USART_RX_Pin,IO_FUNC0);//把原先io SDA变为普通GPIO |
|---|
| | | gpio_pin_set_dir(_4G_USART_RX_Pin , GPIO_DIR_IN, 0); |
|---|
| | | io_pull_set(_4G_USART_RX_Pin, IO_PULL_UP, IO_PULL_UP_LEVEL0); |
|---|
| | | gpio_enable_irq(_4G_USART_RX_Pin, GPIO_IRQ_TYPE_FALLING_EDGE, _4Gusart_irq_handler); |
|---|
| | | } |
|---|
| | | void board_button_init(GPIO_IRQ_HANDLER_T irq_handler) |
|---|
| | | { |
|---|
| | |
|---|
| | | |
|---|
| | | void board_restore_from_power_down(void) |
|---|
| | | { |
|---|
| | | uart_open(UART_ID1, &test_uart_cfg); |
|---|
| | | |
|---|
| | | #if defined(UCI_INTF_PORT) |
|---|
| | | uci_tl_resume(); |
|---|
| | | #else |
|---|
