| | |
|---|
| | | hardware_pici = STMFLASH_ReadHalfWord(FLASH_HARDWARE_VERSION_MAP+2); |
|---|
| | | hardware_type = STMFLASH_ReadHalfWord(FLASH_HARDWARE_VERSION_MAP+4); |
|---|
| | | //deca_sleep(1000); |
|---|
| | | g_com_map[VERSION] = (1<<8)|19; |
|---|
| | | g_com_map[VERSION] = (1<<8)|20; |
|---|
| | | // g_com_map[DEV_ID]=1158; |
|---|
| | | g_com_map[GROUP_ID]=0; |
|---|
| | | // g_com_map[COM_INTERVAL] = 1000; |
|---|
| | |
|---|
| | | { |
|---|
| | | SystemClock_Config(); |
|---|
| | | irq_num++; |
|---|
| | | HAL_GPIO_WritePin(GPIOA, GPIO_PIN_12, GPIO_PIN_SET); |
|---|
| | | RadioIrqProcess(); |
|---|
| | | } |
|---|
| | | if(GPIO_Pin == GPIO_PIN_1)//按键 |
|---|
| | |
|---|
| | | MX_LPUART1_UART_Init(); |
|---|
| | | MX_LPTIM1_Init(); |
|---|
| | | /* USER CODE BEGIN 2 */ |
|---|
| | | |
|---|
| | | GPIO_InitTypeDef GPIO_InitStruct = {0}; |
|---|
| | | /*Configure GPIO pin Output Level */ |
|---|
| | | HAL_GPIO_WritePin(GPIOA, GPIO_PIN_12, GPIO_PIN_RESET); |
|---|
| | | |
|---|
| | | /*Configure GPIO pins : PA2 PA8 */ |
|---|
| | | GPIO_InitStruct.Pin = GPIO_PIN_12; |
|---|
| | | GPIO_InitStruct.Mode = GPIO_MODE_OUTPUT_PP; |
|---|
| | | GPIO_InitStruct.Pull = GPIO_NOPULL; |
|---|
| | | GPIO_InitStruct.Speed = GPIO_SPEED_FREQ_LOW; |
|---|
| | | HAL_GPIO_Init(GPIOA, &GPIO_InitStruct); |
|---|
| | | |
|---|
| | | |
|---|
| | | |
|---|
| | | LED2_TB_ON; |
|---|
| | | Program_Init(); |
|---|
| | | LIS3DH_Data_Init(); |
|---|
