From 1f4cdd2361ab73f24f104d608421124140f54c51 Mon Sep 17 00:00:00 2001
From: zhangbo <zhangbo@qq.com>
Date: 星期二, 13 五月 2025 09:39:48 +0800
Subject: [PATCH] 未修改室内外版本
---
keil/include/main/main.c | 119 ++++++++++++++++++++++++++++++++++++++---------------------
1 files changed, 77 insertions(+), 42 deletions(-)
diff --git a/keil/include/main/main.c b/keil/include/main/main.c
index 6794335..ba1cfde 100644
--- a/keil/include/main/main.c
+++ b/keil/include/main/main.c
@@ -44,7 +44,7 @@
#define UWB_OPEN_COUNT 1
#define UWB_MEASUREMENT_INTERVAL 5
-#define UWB_MEASUREMENT_INTERVAL_SLEEP 60
+#define UWB_MEASUREMENT_INTERVAL_SLEEP 30
extern uint8_t mUsartReceivePack[100];
extern uint8_t mUsart2ReceivePack[150];
@@ -79,11 +79,7 @@
} Operation_step;
Operation_step UWB_work_state;
-// 定义状态
-typedef enum {
- STATE_NORMAL, // 正常状态，3秒测距上传一次
- STATE_SLEEP // 休眠状态，1分钟测距上传一次
-} CountState_t;
+
uint32_t uwb_time_count = 0; // 定时器计数值
//uint32_t step_count = 0; // 步数计数
@@ -114,7 +110,7 @@
.flow = UART_FLOW_CONTROL_NONE,
.rx_level = UART_RXFIFO_CHAR_1,
.tx_level = UART_TXFIFO_EMPTY,
- .baud = BAUD_9600,
+ .baud = BAUD_115200,
#if (TEST_UART_MODE == TEST_UART_POLL_MODE)
.dma_en = false,
.int_rx = false,
@@ -144,8 +140,9 @@
deep_sleep_falg=0;
PCA9555_Set_One_Value_Output(LED_POWER,0);//输出低电平关闭LED
PCA9555_Set_One_Value_Output(GPS_POWER,0);//关闭gps，4G
- PCA9555_Set_One_Value_Config(MAIN_RI,0);//配置4G唤醒引脚为输入
-// PCA9555_Set_One_Value_Output(MAIN_RI,1);
+// PCA9555_Set_One_Value_Config(MAIN_RI,0);//配置4G唤醒引脚为输入
+//
+//// PCA9555_Set_One_Value_Output(MAIN_RI,1);
boot_deinit();
CloseUWB();
PCA9555_Set_One_Value_Output(AIR780E_ENBALE,0);//关闭gps，4G
@@ -181,16 +178,20 @@
bat_percent = ((fVoltage_mv - 3300) /8);
}
}
- if(fVoltage_mv<3300)
- {
- //power_low_flag=1;
- //gps_air780_power_change(gps_power_state,0);//gps原样，关闭4G
-// LOG_INFO(TRACE_MODULE_APP, "电池电压低于3.3V，4G，GPS停止工作\r\n");
- }else{
- //power_low_flag=0;
- //gps_air780_power_change(gps_power_state,1);//gps原样,开启4G
-// LOG_INFO(TRACE_MODULE_APP, "电池电压正常,4G，GPS,正常工作\r\n");
- }
+ if(bat_percent>100)
+ bat_percent=100;
+ if(bat_percent<0)
+ bat_percent=0;
+// if(fVoltage_mv<3300)
+// {
+// //power_low_flag=1;
+// //gps_air780_power_change(gps_power_state,0);//gps原样，关闭4G
+//// LOG_INFO(TRACE_MODULE_APP, "电池电压低于3.3V，4G，GPS停止工作\r\n");
+// }else{
+// //power_low_flag=0;
+// //gps_air780_power_change(gps_power_state,1);//gps原样,开启4G
+//// LOG_INFO(TRACE_MODULE_APP, "电池电压正常,4G，GPS,正常工作\r\n");
+// }
PCA9555_Set_One_Value_Output(ADC_MINIUS,1);//拉高
}
extern uint8_t gps_uwb_flag,gps_need_data_flag;
@@ -210,6 +211,14 @@
power_wakeup_enable((enum POWER_WAKEUP_SOURCE_T)PCA_INPUT_DETECT, POWER_WAKEUP_LEVEL_LOW);
mcu_deep_sleep();
}
+}
+void powerON_Task(void)
+{
+if(deep_sleep_falg==0)
+{
+PCA9555_Set_One_Value_Output(PWR_ENABLE,1);
+}
+
}
void UserKeyTask(void)
{
@@ -307,19 +316,26 @@
}
uint8_t tt=1;
uint8_t flag_sleeptimer,flag_secondtask,secondtask_count,log_4g_enable_flag;
-uint8_t uwb_enable_flag=0;
+uint8_t uwb_offtime_count=0;
uint8_t input5v_time;
extern uint8_t taglist_num;
uint8_t gps_ntripsend;
static void sleep_timer_callback(void *dev, uint32_t time)
{
+// powerON_Task();
if(secondtask_count++%2==0)
{
input5v_time=1;
flag_secondtask = 1;
#ifdef UWB_1_5HZ
uwb_time_count++;
- #endif
+ #endif
+ uwb_offtime_count++;
+ if(uwb_offtime_count>60)
+ {
+ uwb_offtime_count=0;
+ current_state = STATE_SLEEP;
+ }
if(!read_5v_input_pca())
{
if(bat_percent>15)
@@ -431,7 +447,7 @@
}
g_com_map[MODBUS_MODE] = 0;
log_4g_enable_flag=g_com_map[LOG_4G_ENABLE];
- g_com_map[VERSION] = (1<<8)|8;
+ g_com_map[VERSION] = (1<<8)|16;
LOG_INFO(TRACE_MODULE_APP,"设备ID: %x .\r\n",dev_id);
@@ -555,7 +571,8 @@
}
}
}
- NVIC_SystemReset();
+// NVIC_SystemReset();
+// PCA9555_Set_One_Value_Output(PWR_ENABLE,0);
input5vflag=1;
}
else
@@ -567,7 +584,13 @@
state5V_prase_flag=state5v;
gps_prase_flag=1;//恢复gps解析
uart1_change_from_debug_to_gps();//测试
- PCA9555_Set_One_Value_Output(MCU_A,0);//输出低电平切换为GPS
+// PCA9555_Set_One_Value_Output(MCU_A,0);//输出低电平切换为GPS
+ PCA9555_Set_One_Value_Output(LED_POWER,0);//输出低电平关闭LED
+ PCA9555_Set_One_Value_Output(AIR780E_ENBALE,0);
+ PCA9555_Set_One_Value_Output(GPS_POWER,0);//关GPS
+ PCA9555_Set_One_Value_Output(PWR_ENABLE,0);//低电平关闭
+ delay_us(1000000);
+
}
}
UART_CheckReceive();
@@ -613,48 +636,51 @@
void upload_apppoll()
{
uint32_t elapsed_time_jibu;
-#ifdef UWB_1_5HZ
-
switch (current_state)
{
+#ifdef UWB_1_5HZ
case STATE_NORMAL:
elapsed_time_jibu = uwb_time_count - state_start_time;
switch(elapsed_time_jibu)
{
case UWB_OPEN_COUNT:
CloseUWB();
-// uwbled = LEDOFF;
UWBSendUDPTask();
- GPS_UPLOAD_FLAG=1;
+
break;
case UWB_MEASUREMENT_INTERVAL:
- OpenUWB();
-// uwbled = WHITE;
+ taglist_num = 0;
+ CloseUWB();
+ Uwb_init();
+ OpenUWB();
state_start_time = uwb_time_count;
break;
}
break;
+#endif
case STATE_SLEEP:
elapsed_time_jibu = uwb_time_count - state_start_time;
switch(elapsed_time_jibu)
{
case UWB_OPEN_COUNT:
-
- CloseUWB();
+ CloseUWB();
+ UWBSendUDPTask();
break;
case UWB_MEASUREMENT_INTERVAL_SLEEP:
-
- OpenUWB();
- state_start_time = uwb_time_count;
+ taglist_num = 0;
+ CloseUWB();
+ Uwb_init();
+ OpenUWB();
+ state_start_time = uwb_time_count;
break;
}
break;
}
-#endif
+
}
uint8_t flag_4guart_needinit=0;
@@ -665,12 +691,17 @@
uint32_t test4;
extern uint8_t receive_flag;
int main(void)
-{
+ {
__enable_irq();
board_clock_run();
boot_deinit();
board_pins_config();
+ gpio_open();
+ IIC2_Init();
+ Accelerometer_Init();
+ PCA9555_init();
board_debug_console_open_baud(TRACE_PORT_UART1,BAUD_115200);
+
// Reset reason
reset_cause_get();
reset_cause_clear();
@@ -684,7 +715,7 @@
}
else
{
- board_calibration_params_default();
+ board_calibration_params_default();
}
calib_chip();
wdt_close(WDT_ID0);
@@ -706,11 +737,11 @@
TCPClient_Init_1();
}
// HTTPClient_Init();
- gpio_open();
+
LED_output_init();//配置彩色灯引脚
- IIC2_Init();
- Accelerometer_Init();
- PCA9555_init();
+
+
+ WT588E02B_Init();
adc_open(&usr_adc_cfg);
uart_receive(UART_ID1,m_EUART_DMA_RXBuf,EUART_RX_BUF_SIZE,uart_receive_callback);
power_init();
@@ -740,8 +771,12 @@
gps_prase_flag=1;//恢复gps解析
uart1_change_from_debug_to_gps();//测试
PCA9555_Set_One_Value_Output(MCU_A,0);//输出低电平切换为GPS
+ #ifdef UWB_CG
+ CloseUWB();
+ #endif
while (1)
{
+
uwb_app_poll();
Internet_Poll();
HIDO_TimerPoll();
--
Gitblit v1.9.3