From 392e73cb409b1a8f295eafeac078f81b3904f9ec Mon Sep 17 00:00:00 2001
From: WXK <287788329@qq.com>
Date: 星期二, 06 五月 2025 16:50:36 +0800
Subject: [PATCH] 1.10，加入ota语音tts
---
keil/include/main/main.c | 111 +++++++++++++++++++++++++++++++++++++++++++++++--------
1 files changed, 95 insertions(+), 16 deletions(-)
diff --git a/keil/include/main/main.c b/keil/include/main/main.c
index 66bbcb6..9155608 100644
--- a/keil/include/main/main.c
+++ b/keil/include/main/main.c
@@ -28,6 +28,7 @@
//#define DEBUG_MODE
extern int simple_main(void);
extern int temp_main(void);
+void boot_deinit(void);
#define TEST_UART_POLL_MODE 0
#define TEST_UART_INTERUPT_MODE 1
#define TEST_UART_DMA_MODE 2
@@ -39,6 +40,10 @@
#define WARING_LIMIT_TIME 10
#define UPDATE_TIME 10
+
+#define UWB_OPEN_COUNT 1
+#define UWB_MEASUREMENT_INTERVAL 3
+#define UWB_MEASUREMENT_INTERVAL_SLEEP 60
extern uint8_t mUsartReceivePack[100];
extern uint8_t mUsart2ReceivePack[150];
@@ -71,8 +76,20 @@
LINK_SUCCESS,
SEARCH_DEV,
} Operation_step;
-Operation_step UWB_work_state;
+Operation_step UWB_work_state;
+// 定义状态
+typedef enum {
+ STATE_NORMAL, // 正常状态，3秒测距上传一次
+ STATE_SLEEP // 休眠状态，1分钟测距上传一次
+} CountState_t;
+
+uint32_t uwb_time_count = 0; // 定时器计数值
+//uint32_t step_count = 0; // 步数计数
+//uint32_t last_step_count = 0; // 上一次步数
+
+CountState_t current_state = STATE_NORMAL; // 当前状态
+uint32_t state_start_time = 0; // 状态开始时间
Commend_SendDate send_struct;
struct ADC_CFG_T usr_adc_cfg = {
@@ -115,22 +132,31 @@
{
uart_receive(UART_ID1,m_EUART_DMA_RXBuf,EUART_RX_BUF_SIZE,uart_receive_callback);
}
+uint8_t deep_sleep_falg=1;
void mcu_deep_sleep(void)
{
- uint32_t lock;
- trace_flush();
- lock = int_lock();
-// LOG_INFO(TRACE_MODULE_APP, "进入深度休眠\r\n");
+// uint32_t lock;
+// trace_flush();
+// lock = int_lock();
+//// LOG_INFO(TRACE_MODULE_APP, "进入深度休眠\r\n");
// gps_air780_power_change(0,0);//关闭gps，4G
+ deep_sleep_falg=0;
PCA9555_Set_One_Value_Output(LED_POWER,0);//输出低电平关闭LED
PCA9555_Set_One_Value_Output(GPS_POWER,0);//关闭gps，4G
+ PCA9555_Set_One_Value_Config(MAIN_RI,0);//配置4G唤醒引脚为输入
+// PCA9555_Set_One_Value_Output(MAIN_RI,1);
+ boot_deinit();
+ CloseUWB();
PCA9555_Set_One_Value_Output(AIR780E_ENBALE,0);//关闭gps，4G
- sleep_timer_stop();
- //adc_close();
- power_enter_power_down_mode(1);
-// LOG_INFO(TRACE_MODULE_APP, "从休眠出来\r\n");
- sys_reset(0);
- int_unlock(lock);
+
+// sleep_timer_stop();
+// //adc_close();
+// power_enter_power_down_mode(1);
+// delay_us(200000);
+
+// sys_reset(0);
+//// LOG_INFO(TRACE_MODULE_APP, "从休眠出来\r\n");
+// int_unlock(lock);
}
static void adc_callback(void *data, uint32_t number)
{
@@ -145,7 +171,7 @@
{
bat_percent = 0;
}
- else if(fVoltage_mv > 4100)
+ else if(fVoltage_mv > 4200)
{
bat_percent = 100;
}
@@ -180,6 +206,7 @@
{
if(nomove_count>g_com_map[NOMOVESLEEP_TIME]&&g_com_map[IMU_ENABLE]==1)
{//power_wakeup_enable((enum POWER_WAKEUP_SOURCE_T)ACCLERATE_DETECT_Pin, POWER_WAKEUP_LEVEL_HIGH);
+ power_wakeup_enable((enum POWER_WAKEUP_SOURCE_T)PCA_INPUT_DETECT, POWER_WAKEUP_LEVEL_LOW);
mcu_deep_sleep();
}
}
@@ -349,6 +376,7 @@
send_struct.alarmDistence=prewarning_distance;//更新报警距离
memcpy(&send_struct.gunLableId,&g_com_map[BIND_DEV_ID],2);//更新绑定ID
send_struct.tagId=dev_id;//更新设备ID
+ tag_frequency = 1000/g_com_map[COM_INTERVAL];
// g_com_map[IP_0]=111;
// g_com_map[IP_1]=198;
@@ -398,7 +426,7 @@
}
g_com_map[MODBUS_MODE] = 0;
log_4g_enable_flag=g_com_map[LOG_4G_ENABLE];
- g_com_map[VERSION] = (1<<8)|7;
+ g_com_map[VERSION] = (1<<8)|10;
LOG_INFO(TRACE_MODULE_APP,"设备ID: %x .\r\n",dev_id);
@@ -451,7 +479,7 @@
{
nomove_count = 0;
// adctick = HIDO_TimerGetTick();
- if(HIDO_TimerGetTick()-adctick>60) //10分钟采样一次 电量
+ if(HIDO_TimerGetTick()-adctick>600) //10分钟采样一次 电量
{
chongman_time=chongman_time+60;
adctick = HIDO_TimerGetTick();
@@ -463,7 +491,7 @@
only_one_flag=1;
chongman_time=0;
}
- if(bat_percent>=99&&chongman_time>=600)
+ if(bat_percent>=99&&chongman_time>=180)
{
powerled = GREEN;
}else{
@@ -507,6 +535,7 @@
g_com_map[CNT_RESTART]=0;
save_com_map_to_flash();
NVIC_SystemReset();
+
}
}
else
@@ -541,7 +570,7 @@
{
g_com_map[CNT_RESTART]=0;
NVIC_SystemReset();
-
+
}
if(g_com_map[MAP_SIGN_INDEX]!=0x55AA||g_com_map[COM_INTERVAL]==0)
{
@@ -564,11 +593,58 @@
// UART0 TX/RX
io_pin_mux_set(IO_PIN_5, IO_FUNC0);
io_pin_mux_set(IO_PIN_6, IO_FUNC0);
+ gpio_pin_set_dir(IO_PIN_5 , GPIO_DIR_OUT, 0);
+ gpio_pin_set_dir(IO_PIN_6 , GPIO_DIR_OUT, 0);
// UART1 RX/TX
io_pin_mux_set(IO_PIN_10, IO_FUNC0);
io_pin_mux_set(IO_PIN_9, IO_FUNC0);
+
uart_close(UART_ID1);//解绑原来串口1
uart_close(UART_ID0);//解绑原来串口0
+}
+
+extern uint32_t uwb_time_count;
+void upload_apppoll()
+{
+ uint32_t elapsed_time_jibu;
+
+ switch (current_state)
+ {
+ case STATE_NORMAL:
+ elapsed_time_jibu = uwb_time_count - state_start_time;
+ switch(elapsed_time_jibu)
+ {
+ case UWB_OPEN_COUNT:
+ CloseUWB();
+ uwbled = LEDOFF;
+ break;
+
+ case UWB_MEASUREMENT_INTERVAL:
+ OpenUWB();
+ uwbled = BLUE;
+ state_start_time = uwb_time_count;
+ break;
+ }
+ break;
+
+ case STATE_SLEEP:
+ elapsed_time_jibu = uwb_time_count - state_start_time;
+ switch(elapsed_time_jibu)
+ {
+ case UWB_OPEN_COUNT:
+
+ CloseUWB();
+ break;
+
+ case UWB_MEASUREMENT_INTERVAL_SLEEP:
+
+ OpenUWB();
+ state_start_time = uwb_time_count;
+ break;
+ }
+ break;
+ }
+
}
uint8_t flag_4guart_needinit=0;
@@ -580,6 +656,7 @@
extern uint8_t receive_flag;
int main(void)
{
+ __enable_irq();
board_clock_run();
boot_deinit();
board_pins_config();
@@ -624,6 +701,7 @@
IIC2_Init();
Accelerometer_Init();
PCA9555_init();
+ WT588E02B_Init();
adc_open(&usr_adc_cfg);
uart_receive(UART_ID1,m_EUART_DMA_RXBuf,EUART_RX_BUF_SIZE,uart_receive_callback);
power_init();
@@ -654,6 +732,7 @@
while (1)
{
uwb_app_poll();
+// upload_apppoll();
Internet_Poll();
HIDO_TimerPoll();
HIDO_ATLitePoll();
--
Gitblit v1.9.3