From 07691209317d73ebe7b89bce522cd43fa4bcadc0 Mon Sep 17 00:00:00 2001
From: zhyinch <zhyinch@gmail.com>
Date: 星期五, 11 六月 2021 17:25:47 +0800
Subject: [PATCH] V1.47 增加NLOS模式
---
源码/核心板/Src/application/dw_app.c | 27 ++++++++++++++++++---------
1 files changed, 18 insertions(+), 9 deletions(-)
diff --git "a/\346\272\220\347\240\201/\346\240\270\345\277\203\346\235\277/Src/application/dw_app.c" "b/\346\272\220\347\240\201/\346\240\270\345\277\203\346\235\277/Src/application/dw_app.c"
index 2ba756b..5ab8cdc 100644
--- "a/\346\272\220\347\240\201/\346\240\270\345\277\203\346\235\277/Src/application/dw_app.c"
+++ "b/\346\272\220\347\240\201/\346\240\270\345\277\203\346\235\277/Src/application/dw_app.c"
@@ -1,6 +1,6 @@
#include "dw_app.h"
#include "ADC.h"
-#define TDFILTER
+//#define TDFILTER
enum enumtagstate
{
DISCPOLL,
@@ -115,6 +115,14 @@
}
}
}
+void SetNLOSNTMSettings(void)
+{
+ uint8_t temp;
+ temp = 7;
+ dwt_writetodevice(LDE_IF_ID,LDE_CFG1_OFFSET,1,&temp);
+ dwt_write16bitoffsetreg(LDE_IF_ID,LDE_CFG2_OFFSET,3);
+ // NTM = dwt_read32bitoffsetreg(LDE_IF_ID,LDE_CFG1_OFFSET) & LDE_CFG1_NSTDEV_MASK;
+}
void Dw1000_Init(void)
{
/* Reset and initialise DW1000.
@@ -127,7 +135,7 @@
/* Configure DW1000. See NOTE 6 below. */
dwt_configure(&config);//配置DW1000
-
+ SetNLOSNTMSettings();
/* Apply default antenna delay value. See NOTE 1 below. */
dwt_setrxantennadelay(RX_ANT_DLY); //设置接收天线延迟
@@ -449,6 +457,7 @@
memcpy(&rec_tagpos_binary,&rx_buffer[NEARMSG_EMPTYSLOTPOS_INDEX],4);
if(temp_dist!=0x1ffff)
{
+ g_Resttimer=0;
#ifndef USART_INTEGRATE_OUTPUT
usart_send[2] = 1;//正常模式
usart_send[3] = 17;//数据段长度
@@ -700,7 +709,6 @@
{
//LED0_ON;
dwt_forcetrxoff();
- g_Resttimer=0;
GPIO_WriteBit(GPIOA, GPIO_Pin_10, Bit_SET);
switch(tag_state)
{
@@ -922,13 +930,14 @@
/*--------------------------以下为非测距逻辑------------------------*/
//dist_cm=33000;
getrange_success = 1;
+ g_Resttimer=0;
LED0_BLINK; //每成功一次通讯则闪烁一次
dis_after_filter=dist_cm;
hex_dist = dist_cm+(int16_t)g_com_map[DIST_OFFSET]*10;
g_flag_Taggetdist[taglist_pos]=0;
- if(hex_dist>-10000&&hex_dist<2000000)
+ if(hex_dist>0&&hex_dist<2000000)
{
- if(abs(hex_dist-his_dist[taglist_pos])<15000||misdist_num[taglist_pos]>3)
+ if(abs(hex_dist-his_dist[taglist_pos])<10000||misdist_num[taglist_pos]>3)
{
int32_t filter_dist;
#ifdef TDFILTER
@@ -1009,8 +1018,7 @@
// if (anchor_type == rx_buffer[ANC_TYPE_IDX])
// Anchor_RecPoll();
// break;
- case SYNC:
- g_Resttimer=0;
+ case SYNC:
memcpy(&rec_syncid,&rx_buffer[ANCHOR_ID_IDX],4);
if(rec_syncid<current_syncid)
{
@@ -1051,9 +1059,10 @@
}
break;
- case NEAR_POLL:
- g_Resttimer=0;
+ case NEAR_POLL:
memcpy(&tag_id_recv,&rx_buffer[TAG_ID_IDX],2);
+ if(tag_id_recv>=g_com_map[WHITELIST1_START]&&tag_id_recv<=g_com_map[WHITELIST1_END])
+ {break;}
taglist_pos=CmpTagInList(tag_id_recv);
if(taglist_pos==taglist_num)
{
--
Gitblit v1.9.3