# Licensed to the Apache Software Foundation (ASF) under one
# or more contributor license agreements.  See the NOTICE file
# distributed with this work for additional information
# regarding copyright ownership.  The ASF licenses this file
# to you under the Apache License, Version 2.0 (the
# "License"); you may not use this file except in compliance
# with the License.  You may obtain a copy of the License at
#
#  http://www.apache.org/licenses/LICENSE-2.0
#
# Unless required by applicable law or agreed to in writing,
# software distributed under the License is distributed on an
# "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY
# KIND, either express or implied.  See the License for the
# specific language governing permissions and limitations
# under the License.
#

syscfg.defs:
    BLE_PHY_SYSVIEW:
        description: >
            Enable SystemView tracing module for radio driver.
        value: 0

    BLE_PHY_DBG_TIME_TXRXEN_READY_PIN:
        description: >
            When set to proper GPIO pin number, this pin will be set
            to high state when radio is enabled (TASKS_TXEN or TASKS_RXEN)
            and back to low state on radio EVENTS_READY.
            This can be used to measure radio ram-up time.

            Note:
            GPIO control for selected pin needs to be assigned to Network
            Core, configure IPC_NRF5340_NET_GPIO in ipc_nrf5340 driver on
            Application Core.
        value: -1

    BLE_PHY_DBG_TIME_ADDRESS_END_PIN:
        description: >
            When set to proper GPIO pin number, this pin will be set
            to high state on radio EVENTS_ADDRESS and back to low state
            on radio EVENTS_END.
            This can be used to measure radio pipeline delays.

            Note:
            GPIO control for selected pin needs to be assigned to Network
            Core, configure IPC_NRF5340_NET_GPIO in ipc_nrf5340 driver on
            Application Core.
        value: -1

    BLE_PHY_DBG_TIME_WFR_PIN:
        description: >
            When set to proper GPIO pin number, this pin will be set
            to high state on radio EVENTS_RXREADY and back to low
            state when wfr timer expires.
            This can be used to check if wfr is calculated properly.

            Note:
            GPIO control for selected pin needs to be assigned to Network
            Core, configure IPC_NRF5340_NET_GPIO in ipc_nrf5340 driver on
            Application Core.
        value: -1